| View previous topic :: View next topic |
| Author |
Message |
apopilot
EVDO Newbie
Joined: 14 Feb 2006
Posts: 9
|
 Posted: Wed Apr 09, 2008 12:01 am Post subject: u727 Firmware not updating |
 |
|
| I installed the U727 software that came with and activated my modem. I then downloaded the latest software build from sprint.com/downloads. I noticed when I plug in my modem to my latop it states their is a firmware update but then it fails. Any ideas? |
|
| Back to top |
|
 |
asimek_phx
EVDO Fledgling
Joined: 14 Apr 2008
Posts: 12
|
| Posted: Mon Apr 14, 2008 8:54 am Post subject: Firmware not being applied |
|
|
The firmware file requires that you be logged in as Administrator if you are running Vista.
Vista was a real pain in the arse for me with this firmware update, but if you log in as Administrator and do the same update, or if you can find the update file and right click and run as adminstrator, it will go through ok.
Tony |
|
| Back to top |
|
|
ebiz
EVDO Junkie
Joined: 25 Oct 2006
Posts: 388
Location: Reno, NV
|
| Posted: Mon Apr 14, 2008 9:42 pm Post subject: Re: Firmware not being applied |
|
|
| asimek_phx wrote: | | The firmware file requires that you be logged in as Administrator if you are running Vista... |
Tony, were you using Vista 32 or 64?
Which SCM are you using: Novatel 3.10.014 or Sprint SmartView for Windows 1.12.0015.0?
_________________
Vista64 & EX720 |
|
| Back to top |
|
|
asimek_phx
EVDO Fledgling
Joined: 14 Apr 2008
Posts: 12
|
| Posted: Tue May 13, 2008 4:10 pm Post subject: Running vista32 and the new scm dialer |
|
|
| I had this problem with vista32 and the new scm dialer, but doubt that it would behave any different in 64bit vista. |
|
| Back to top |
|
|
ebiz
EVDO Junkie
Joined: 25 Oct 2006
Posts: 388
Location: Reno, NV
|
| Posted: Tue May 13, 2008 5:19 pm Post subject: |
|
|
Well try to use Novatel SCM 3.10.014. It works just great.
_________________
Vista64 & EX720 |
|
| Back to top |
|
|
curt504
EVDO Fledgling
Joined: 07 Dec 2005
Posts: 16
|
| Posted: Tue May 13, 2008 7:50 pm Post subject: |
|
|
FYI 3.10.14 continuously wants to update for me. Every boot it wants to update the PRL. I pull out the card click yes, Ok for failure, push in the card to find-card and log on. I'm tired of low quality software!!
I have an old SCM version that doesn't do this (??) but some issue has caused a hang in my XP bootup and figured I'd give a new SCM a try, still the XP hang and now this too. I just haven't gotten to re-install the old SCM.
Great carrier, good card (s620) but crummy software.
curt |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
