MBR1000 DynDNS

dreadlocks · EVDO Newbie Joined: 07 Mar 2008 Posts: 4

Here is my setup.. MBR1k from 3gstore, Sprint 595U & a wireless bridge on WAN. When it falls over to WAN (Comcast) I am behind a NAT but in a DMZ.

It seems like it updates my host when I switch to the EVDO modem, but I figure when it falls over to WAN it see's a non-routable IP and wont update the address. Should it not be able to detect the external IP and update it regardless?

-R

wpeloqui · EVDO Newbie Joined: 11 Apr 2008 Posts: 1

I am having the same problem with dyndns.org. I enabled the setting and saved it. Going back to the setting screen shows that it was never enabled.

Willie

sbonar · EVDO User Joined: 13 Nov 2007 Posts: 81

I've talked to Cradlepoint support about this recently and they said that if the dyndns settings are disabled after you set it up and save it, then that means something is wrong with the credentials you typed in, i.e. bad username or password. They indicated that it should say something in the log (Status->Logs) when this happens.

Also, they indicated that some issues were found and fixed around DynDNS in the next release, which is supposed to be out soon.